Instacast resin5/28/2023 Mix 'Part A and 'Part B' 1:1 by weight.Low viscosity and special flow profile will result in excellent surface finish and minimal air entrapment without degassing. For small or thin-section castings an ambient of 20-25☌ is required. Can be used from 10 to 30☌ although pot-life and cure time will be affected significantly.Wear gloves and goggles and work in a well ventilated area.For hobby or professional use (always follow SDS advice).Although P2 has a good moisture tolerance it is still recommended to avoid moulds or substrates which may harbour excessive levels of moisture. Xencast® P2 should not be cast into latex rubber moulds. Photoluminescent (glow in the dark) powders.All metal powders (for realistic cold castings).Translucent Tinting Pigment (for less vivid opaque colours).Polyurethane Colour Pigment (for vivid opaque colours).Polypropylene and polyethylene mould 'trays'.Addition/platinum cure RTV silicone rubber. Condensation/tin cure RTV silicone rubber.Not a toughened system so less suitable for more structural applicationsĬompatibility Information - Dos and Don'tsĪlthough by no means an exhaustive list, the mould materials, pigments and additives listed below have all been tested and are known to work well with Xencast® P2.Very Short pot-life of just over 2 minutes means you must work quickly.The 2kg kit is also available as part of the Xencast Resin Casting Starter Kit. The resin is available in a choice of 1kg, 2kg and 4kg kits, each containing the correct ratios of Part A and Part B. Very easy to use - compatible with most mould materials.Fine surface detail reproduction with minimal air entrapment.With the addition of ATH filler powder, Xencast® P2 can also be used to reproduce large sculptures, whereas the addition of metal powders and pigments makes it possible to 'cold cast' bronzes and other authentic-looking metallic castings. In conjunction with a suitable mould, Xencast® P2 fast cast resin can be used to all manner of cast parts including beautifully detailed figurines, RPG miniatures, models, patterns, prototype parts, foundry patterns, sculptures, fishing lures, ornaments and architectural features. Whether you're new to casting or a seasoned professional you're sure to get excellent results with this highly regarded resin system. Xencast® P2 pu casting resin is compatible with a wide range of mould materials, fillers, pigments and additives making it the perfect all-purpose casting resin whilst the fast cure time reduces waiting and increases productivity. Its low viscosity and modified flow properties result in superior surface detail with minimal air entrapment. P2 has been formulated for maximum reliability and so requires no degassing and no other specialist equipment. Its unique formulation has been developed to offer the best possible results across a wide range of applications including miniatures, figures, models, patterns, sculptures, prototypes and production parts. Xencast® P2 is an easy-to-use fast-cast polyurethane resin system capable of producing highly detailed castings which can be demoulded within around 10-20 mins.
0 Comments
Leave a Reply. |